![]() Once you sort out these HDMI issues, your TV signal should start working again in a jiffy. ![]() You may want to upgrade your HDMI connector cable to a self-locking one which will help it stay in the port position. (Most TV manufacturers include at least two HDMI ports.)ĭisengage the HDMI cable and re-insert it into the old or new HDMI port. It’s nothing serious that a TV mechanic can’t fix, and you can simply migrate to an alternative HDMI port. If the connections are not fitting tightly or slipping out, there might be slight damage to the ports. In most cases, the reason behind a no signal problem can be traced to either the High-Definition Multimedia Interface (HDMI) cables or the ports. ![]() Later, reinsert the card with the chip facing downward, following any visible arrows. You may also want to pull out the smart card/viewing card and let the cable box cool for a while. Unplug the power cable and insert it once again to solve the problem. This means new satellite settings may have been uploaded, but the device has not fully integrated with the adjustments. Whether you have an SD or HD box, the provider might have released new firmware and proceeded to update it in the background. Your set-top box might be the reason for a no-signal issue in some cases. Should you want to re-enable the motherboard HDMI port, you can sometimes do so by right-clicking the desktop and switching there, but you may need to do that through the BIOS (though generally, it’s better to use the port on the GPU, as you’ll be taking advantage of your GPU’s power that way). Normally, if you have a connected GPU, then the HDMI port on the motherboard will be disabled automatically. If that doesn’t work and your computer has an HDMI port both on its GPU (graphics card) and motherboard, then you need to make sure you’re connected to the right port.If your PC is connected to the TV device, click on “Detect” next to “Detect other display.” In case you have connected them wirelessly, click “Connect” next to “Connect to a Wireless Display.”.If pairing is successful, the Link light on your wireless receiver should turn green. Move your wireless receiver closer to the WAP, then pair them by pressing the WPS button on your WAP and the OK button on your wireless receiver. Your receiver may be too far away from your WAP. If you don’t see a red light or the red light is dim, replace the batteries in the remote.Ĭonnection error on TV or receiver and Wireless Access Point (WAP) not pairing If you see a red light, the batteries are still good. Receiver doesn't respond to the remote controlĬheck the batteries in the remote by pressing the AT&T button on the remote. To stop your receiver from going to standby, simply press a key such as OK, Guide, or Options on your U-verse remote to restart the eight-hour cycle. This feature is in place to conserve energy. Be sure the proper input/source setting is selected.Īfter eight hours of inactivity, your receiver automatically goes to standby mode. Receiver power is on and TV power is on, but I still can't see TVĬheck your TV menu setup. If you’re having a specific problem and restarting the receiver doesn’t fix it, try the tips below. Wait a few minutes, then plug it back in. If no lights are on, ensure that the TV receiver is turned on by pressing and releasing the AT&T button on the remote control, and then pressing. ![]() If you have multiple receivers, reboot your wireless gateway by unplugging it from its power source. This takes 5-8 minutes and will impact any DVR recordings in progress. To do this, press and hold the Power button for 10 seconds. Many receiver problems can be fixed by restarting your receiver.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |